Y
yonick
Hi genjua,
I too, i'm implementing a comm. network between several PM 710, 5.0P and 5.0H via EGX 100 to powerview with TCP/IP.
Connections so far has been ok. The prob. is with launching the powerview...it says that i need to start the powerlogic network server first and i cannot do so, even after dloading and installing the patch given by Schneider electric.
Any recommendations on your part, plz?
when i start it manually, it says "error 1053:the service did not respond to the start in a timely fashion..." !!!!!???
I too, i'm implementing a comm. network between several PM 710, 5.0P and 5.0H via EGX 100 to powerview with TCP/IP.
Connections so far has been ok. The prob. is with launching the powerview...it says that i need to start the powerlogic network server first and i cannot do so, even after dloading and installing the patch given by Schneider electric.
Any recommendations on your part, plz?
when i start it manually, it says "error 1053:the service did not respond to the start in a timely fashion..." !!!!!???