Read and participate in active technical discussions with automation and industrial controls users from all over the world.
Control.com - Nerds in Control
Member Login
Modbus Links
Search
Jump to a Date
Cool stuff
RSS Feed
Use this link to get an RSS feed of the Modbus Community article flow, for private, non-commercial use only:modbus.control.com/rss/
To get a personalized feed, become a member at no cost.
from the Automation department...
IC200CPU001 modbus
Dear all,
I have program for VersaMax CPU001 port 2 as GE Modbus master. After I put PLC at run mode and quit Versa Pro soft. I can not onlive with the PLC through port 2. I think that after I put it to run mode the port work at modbus master, so It does not allows to connect at SNP mode any more. So, I have to reset the CPU and connect again.
Can I connect the CPU through port 1 with Versa Pro. soft ?
Best regards,
I have program for VersaMax CPU001 port 2 as GE Modbus master. After I put PLC at run mode and quit Versa Pro soft. I can not onlive with the PLC through port 2. I think that after I put it to run mode the port work at modbus master, so It does not allows to connect at SNP mode any more. So, I have to reset the CPU and connect again.
Can I connect the CPU through port 1 with Versa Pro. soft ?
Best regards,
Yes, you can communicate SRTP, the programming protocol, through the VersaMax IC200CPU001 Port 1. Standard settings are 19.2, odd parity, 1 stop bit. Port 1 is a 9-pin D-sub RS-232; port 2 is a 15-pin, D-sub, RS-485. typically the second port uses a programming cable with a 232 / 485 converter. When you're connected through port 2, be sure the port settings are correct on port 1.
If your cable is one that allows you disconnect the converter, then remove the converter, attach a gender-changer and attach to port 1. A straight-through 9-pin cable also works.
Drake Fink
Sr. Application Engineer
GE Fanuc Intelligent Platforms
If your cable is one that allows you disconnect the converter, then remove the converter, attach a gender-changer and attach to port 1. A straight-through 9-pin cable also works.
Drake Fink
Sr. Application Engineer
GE Fanuc Intelligent Platforms
Your use of this site is subject to the terms and conditions set forth under Legal Notices and the Privacy Policy. Please read those terms and conditions carefully. Subject to the rights expressly reserved to others under Legal Notices, the content of this site and the compilation thereof is © 1999-2009 Nerds in Control, LLC. All rights reserved.