G
We are trying to built up communication of power meter pm-710 with egx-100.
We have 10 power meters connected in daisy chain and then all the power meter are connected with egx-100. It is written in the manual of EGX-100 that its supports up to 32 devices.
The problem is that we can only get up to 8 power meters values we could not get the values and response of THIRD LAST and LAST power meters (power meter 8th and power meter 10th).
Our communication settings are as follow:
Baud rate: 4800
Parity: none
Tim out: 1 sec
Further we have change the baud rate e.g. (2400 9600 19200) and time out egx-100. but we are not getting the values from the last two power meters of the daisy chain and we have changed the setting of power meter but still same result.
Egx-100 is a gateway to convert MODBUS to MODBUS TCP/IP. We are getting the values from all power meter when they are connected in MODBUS protocol.
Regards,
GENJUA
We have 10 power meters connected in daisy chain and then all the power meter are connected with egx-100. It is written in the manual of EGX-100 that its supports up to 32 devices.
The problem is that we can only get up to 8 power meters values we could not get the values and response of THIRD LAST and LAST power meters (power meter 8th and power meter 10th).
Our communication settings are as follow:
Baud rate: 4800
Parity: none
Tim out: 1 sec
Further we have change the baud rate e.g. (2400 9600 19200) and time out egx-100. but we are not getting the values from the last two power meters of the daisy chain and we have changed the setting of power meter but still same result.
Egx-100 is a gateway to convert MODBUS to MODBUS TCP/IP. We are getting the values from all power meter when they are connected in MODBUS protocol.
Regards,
GENJUA