Master & Slave configuration between 2 PLC Twido TWDLCAE40DRF

K

Thread Starter

kungfupanda

I need solution for master & slave configuration between 2 PLC Twido TWDLCAE40DRF.

My final project is about a system for filling drink on a cup and do the packaging. the component of the project is the filling system (dropping cup, filling water, pressing the seal) and the packing (packing into a box and sealing the box). This project is using 2 PLC Twido TWDLCAE40DRF. My problem is how to configure one of them as the master and the other as the slave. the only port that my plc have is mini-DIN 8 pin and port ethernet.

Is there any reference for the configuration of the plc including the communication?

hope there is any solution to my problem.
 
K
i've already read the manual you've send to me, but i'm not quite sure i understand them. i don't really understand about the communication. can i get any simple step or which cable or port i should use and connect? and also what kind of program should i write on the master either the slave?
 
G

Gsm Commander

Hi :)

You should look into the GSM Commander. Our slave and master sequence is pretty straightforward. we have 2 ports next to each other. the one on the left is the master the one on the right is the slave. Our set up goes: m s / m s / m s.
 
Top